Test IKEv2.EN.I.1.1.2.1: Retransmissions of IKE_SA_INIT requests
Part A: (BASIC)
To verify an IKEv2 device retransmits IKE_SA_INIT request using properly Header and
Payloads format
* [RFC 4306] - Sections 2.1, 2.2 and 2.4
* [RFC 4718] - Sections 2.2 and 2.3
* Network Topology
Connect the devices according to the Common Topology.
* Configuration
In each part, configure the devices according to the Common Configuration. In
addition, set retransmission timer to 1 second.
* Pre-Sequence and Cleanup Sequence
IKEv2 on the NUT is disabled after each part.
NUT TN1
(End-Node) (End-Node)
| |
|------------------->| IKE_SA_INIT request (HDR, SAi1, KEi, Ni)
| | (Judgement #1)
| |
| * wait for the event of a timeout
| |
|------------------->| IKE_SA_INIT request (HDR, SAi1, KEi, Ni)
| | (Judgement #2)
| |
V V
N: USE_TRANSPORT_MODE
Part A: (BASIC)
1. NUT starts to negotiate with TN1 by sending IKE_SA_INIT request.
2. Observe the messages transmitted on Link A.
3. TN1 waits for the event of a timeout on NUT.
4. Observe the messages transmitted on Link A.
Part A
Step 2: Judgment #1
The NUT transmits an IKE_SA_INIT request including "ENCR_3DES",
"PRF_HMAC_SHA1", "AUTH_HMAC_SHA1_96" and "D-H group 2" as proposed
algorithms.
Step 4: Judgment #2
The NUT retransmits an IKE_SA_INIT request which has the same Message ID value as the
previous IKE_SA_INIT request's Message ID value in IKE Header.
* Each NUT has the different retransmission timers. If it is imposibble to configure the
retransmission timer, modifying tester is required.