Test IKEv2.EN.I.1.1.3.7: Sending Delete Payload for CHILD_SA
Part A: (BASIC)
To verify an IKEv2 device transmits a Delete Payload, when CHILD_SAs are deleted.
* [RFC 4306] - Sections 2.4 and 3.11
* Network Topology
Connect the devices according to the Common Topology.
* Configuration
In each part, configure the devices according to the Common Configuration.
In addition, set IKE_SA Lifetime to 300 seconds and set CHILD_SA Lifetime to 30
seconds.
* Pre-Sequence and Cleanup Sequence
IKEv2 on the NUT is disabled after each part.
NUT TN1
(End-Node) (End-Node)
| |
|------------------->| IKE_SA_INIT request (HDR, SAi1, KEi, Ni)
| | (Judgement #1)
|<-------------------| IKE_SA_INIT Response (HDR, SAr1, KEr, Nr)
| | (Packet #1)
| |
|------------------->| IKE_AUTH request (HDR, SK {IDi, AUTH, N, SAi2, TSi, TSr})
| | (Judgement #2)
|<-------------------| IKE_AUTH Response (HDR, SK {IDr, AUTH, N, SAr2, TSi, TSr})
| | (Packet #2)
| |
| * wait until expiring CHILD_SA
| |
|------------------->| INFORMATIONAL request (HDR, SK {D})
| | (Judgement #3)
| |
V V
N: USE_TRANSPORT_MODE
| Packet #1 |
See Common Packet #2 |
| Packet #2 |
See Common Packet #4 |
Part A: (BASIC)
1. NUT starts to negotiate with TN1 by sending IKE_SA_INIT request.
2. Observe the messages transmitted on Link A.
3. TN1 responds with an IKE_SA_INIT response to the NUT.
4. Observe the messages transmitted on Link A.
5. After reception of IKE_AUTH request from the NUT, TN1 responds with an IKE_AUTH
response to the NUT
6. TN1 waits until expiring CHILD_SA's lifetime and TN1 does not respond to an
INFORMATIONAL reques with an INFORMATIONAL request for liveness check.
7. Observe the messages transmitted on Link A.
Part A
Step 2: Judgment #1
The NUT transmits an IKE_SA_INIT request including "ENCR_3DES",
"PRF_HMAC_SHA1", "AUTH_HMAC_SHA1_96" and "D-H group 2" as proposed
lgorithms.
Step 4: Judgment #2
The NUT transmits an IKE_AUTH request including "ENCR_3DES",
"AUTH_HMAC_SHA1_96" and "No Extended Sequence Numbers" as proposed algorithms.
Step 7: Judgment #3
The NUT transmits an INFORMATIONAL request with a Delete Payload including 3 (ESP)
as Protocol ID, 4 as SPI Size and the inbound SPI value to be deleted as SPI.
* None.