Test IKEv2.EN.I.1.1.6.11: Receipt of INVALID_KE_PAYLOAD in Initial Exchange
Part A: IKE_SA Responder's SPI is zero (ADVANCED)
To verify an IKEv2 device properly handles IKE_SA_INIT Response with a Notify payload
of type INVALID_KE_PAYLOAD.
* [RFC 4306] - Sections 2.7, 3.4 and 3.10.1
* [RFC 4718] - Sections 2.1 and 2.2
* Network Topology
Connect the devices according to the Common Topology.
* Configuration
In each part, configure the devices according to the Common Configuration.
* Pre-Sequence and Cleanup Sequence
IKEv2 on the NUT is disabled after each part.
NUT TN1
(End-Node) (End-Node)
| |
|------------------->| IKE_SA_INIT request (HDR, SAi1(DH#2, DH#14), KEi(DH#14), Ni)
| | (Judgement #1)
|<-------------------| IKE_SA_INIT Response (HDR, N(INVALID_KE_PAYLOAD(DH#2)))
| | (Packet #1)
| |
|------------------->| IKE_SA_INIT request (HDR, SAi1(DH#2, DH#14), KEi'(DH#2), Ni)
| | (Judgement #2)
| |
V V
Packet #1: IKE_SA_INIT response
| IPv6 Header |
Same as the Common Packet #2 |
| UDP Header |
Same as the Common Packet #2 |
| IKEv2 Header |
Same as the Common Packet #2 |
| IKE_SA Responder's SPI |
See each Part |
| N Payload |
Next Payload |
0 |
| Critical |
0 |
| Reserved |
0 |
| Payload Length |
10 |
| Protocol ID |
0 |
| SPI Size |
0 |
| Notify Message Type |
INVALID_KE_PAYLOAD (17) |
| Notification Data |
The accepted D-H Group # (2) |
Part A: IKE_SA Responder's SPI is zero (BASIC)
1. NUT starts to negotiate with TN1 by sending IKE_SA_INIT request.
2. Observe the messages transmitted on Link A.
3. TN1 responds with an IKE_SA_INIT Response including a Notify payload of type
INVALID_KE_PAYLOAD containing 2 (1024 Bit MODP) as Notification Data to the NUT.
The message's IKE_SA Responder's SPI is set to zero.
4. Observe the messages transmitted on Link A.
Part A
Step 2: Judgment #1
The NUT transmits an IKE_SA_INIT Request including
"ENCR_3DES", "PRF_HMAC_SHA1", "AUTH_HMAC_SHA1_96", "D-H group 2" and "D-H
group 14" as proposed algorithms. KEi payload must carry "D-H group 14" public key
value.
Step 4: Judgment #2
The NUT transmits an IKE_SA_INIT request including a Key Exchange payoad which
contains "D-H group 2" public key value. All other payloads are unchanged.
* None.