Test IKEv2.EN.I.2.1.1.2: Use of CHILD_SA
Part A (BASIC)
To verify an IKEv2 device properly handles the Initial Exchanges using Pre-shared key
* [RFC 4306] - Sections 1.2
* Network Topology
Connect the devices according to the Common Topology.
* Configuration
In each part, configure the devices according to the Common Configuration.
* Pre-Sequence and Cleanup Sequence
IKEv2 on the NUT is disabled after each part.
NUT TN1 TH1
(End-Node) (SGW) (Host)
| | |
|------------->| | IKE_SA_INIT request (HDR, SAi1, KEi, Ni)
| | | (Judgement #1)
|<-------------| | IKE_SA_INIT Response (HDR, SAr1, KEr, Nr)
| | | (Packet #1)
| | |
|------------->| | IKE_AUTH request (HDR, SK {IDi, AUTH, SAi2, TSi, TSr})
| | | (Judgement #2)
|<-------------| | IKE_AUTH Response (HDR, SK {IDr, AUTH, SAr2, TSi, TSr})
| | | (Packet #2)
| | |
|<=============+-------------| IPSec {Echo Request}
| | | (Packet #3)
|==============+------------>| IPSec {Echo Reply}
| | | (Judgement #3)
| | |
V V V
| Packet #1 |
See Common Packet #2 |
| Packet #2 |
See Common Packet #6 |
| Packet #3 |
See Common Packet #20 |
Part A (BASIC)
1. NUT starts to negotiate with TN1 by sending IKE_SA_INIT request.
2. Observe the messages transmitted on Link A.
3. TN1 responds with an IKE_SA_INIT response to the NUT.
4. Observe the messages transmitted on Link A.
5. After reception of IKE_AUTH request from the NUT, TN1 responds with an IKE_AUTH
response to the NUT
6. TH1 transmits an Echo Request and TN1 forwards an Echo Request with IPsec ESP using
corresponding algorithms to NUT.
7. Observe the messages transmitted on Link A.
Part A
Step 2: Judgment #1
The NUT transmits an IKE_SA_INIT request including "ENCR_3DES",
"PRF_HMAC_SHA1", "AUTH_HMAC_SHA1_96" and "D-H group 2" as proposed
algorithms.
Step 4: Judgment #2
The NUT transmits an IKE_AUTH request including "ENCR_3DES",
"AUTH_HMAC_SHA1_96" and "No Extended Sequence Numbers" as proposed algorithms.
Step 7: Judgment #3
The NUT transmits an Echo Reply with IPsec ESP using ENCR_3DES an
AUTH_HMAC_SHA1_96.
None.